Wireless Fire Alarm Photoelectric Smoke Detector Smoke Sensor

Wolf-Guard Fire alarm Photoelectric Smoke Detector (YG-05)

Wireless Smoke Detector YG-05
User Guide
I.  Introduction
   YG-05 adopts high-quality photoelectric sensor, with high sensitivity & stability and low power consumption. Self-checking circuit and power supply, easy to install and operate. Please keep this device away from following places:
l       Places with normal smoke exist,
l       Places with dust, fog, steam, erosion gas,
l       Humidity higher than 95%,
l       Wind speed higher than 5m/second.
 

II. Features
YG-05 adopts independent photoelectric sensor, can effectively detects smoke generated at the first stage of fire accident. The smoke enter the detector will make dispersion of light, and sensor will perceive the light intensity, when the light intensity reach preset level, sensor will launch fire alarm signal, red indicating light will flash and start buzzer warning sound.
l       Intelligently detect smoke,
l       Intelligently self check battery voltage,
l       Could be connected with wireless home alarm system.
 
III. Operation
 
1. Self- checking
Self-checking function used for check power supply and circuit condition, once a week.
Press Test button once, smoke detector emits emergency alarming code, led light flashing and siren start to sound.
2. Alarming
Normally, the detector led light flashes every one minute, detects every two seconds. Detector will launch alarm when it detects smoke intensity reached preset level, flashes led light and sound siren for 1 minute, press Test button can stop the alarming sound, detector will detect again after 10 seconds.
3. Battery check
Device will self-check its battery voltage every one minute, when voltage lowers than 6.8V, led light will flash and make di di di di sound to remind low voltage, please change new battery to make it work normally.
4. Pair with alarm system
Detector could be coded to work with home alarm system, alarm panel under coding status, then press Test button of the detector to emit wireless signal, alarm panel will receive and confirm it. Successfully coded smoke detector will send detected signal to alarm system to call or SMS text users for warning.
 
IV. Technical Parameters
 
Power supply: DC9V(battery)
          9~12V DC Adapter(optional)
Working Current: Detect status <10uA, Alarming status < 15mA
Sensor Sensitivity: Second class
Siren Volume: 85dB
Wireless Frequency: 433MHz
Transmission Distance: >80M(no obstacle)
External touch voltage for alarming: 3V DC
Temperature: -10ºC~+60ºC
Humidity: 95% (40±2ºC)
Detect Area: installed height within 6m, detect area of 60 square meters.
Battery Life: one 9V battery last over 1 year.
Size: Φ128mmX41mm
Weight: 175g(contain battery)
 
V. Installation and Test
Detector normally ceiling installed with a maximum height of 6 meters, can detect about 60 square meters area below.
Drill two holes on the ceiling with a 80mm distance, use self-tapping screw to fix the device base, then spin the smoke detector (which with battery inside and tested) into the base carefully, see below indicating chart.

 
 
Remarks:
We provide this smoke detector with one-year guarantee.
Please read this simple manual guide before use it.
Thank you.