MULTI-MOUNT CYLINDER
CU SERIES
INSTALL AND APPLICATION
1. When load changes in the work, the cylinder with abundant output capacity shall be selected
2. Relative cylinder with high temperature resistance or corrosion resistance shall be chosen under the condition of high temperature or corrosion
3. Necessary protection measure shall be taken in the environment with larger humidity, much dust or water drops, oil dust and welding dregs
4. Dirty substances in the pipe must be cleared away before cylinder is connected with pipeline to prevent the entrance of sundries into the cylinder
5. The medium used by cylinder shall be filtered by the filter core of the above 40um
6. Anti-freezing measure shall be adopted under low temperature environment to prevent moisture freezing
7. The cylinder shall be carried out test run without load before application. Prior to run, buffer shall be turned to the minimum and
gradually released to avoid the damager on cylinder caused by excessive impact
8. The cylinder shall avoid the influence of side load in operation to maintain the normal work of cylinder and extend the service life
9. If the cylinder is dismantled and stored for a long time, please conduct anti-rust treatment to the surface. Anti-dust jam cap shall be
added in air intake and outlet orifices.
ORDERING CODE
FEATURE
1. Standard cylinder manufactured by our company
2. Easy for fixing, kinds fix way
3. Save space when fixing
4. It adopts lengthening type sliding supporting guide. No additional lubricant is
needed and it has good performance of guide
5. Kinds types for customer choose
6. The seal material with high temperature resistance is adopted to guarantee the
normal operation of cylinder at 150 C (Option)
TECHNICAL SHEET |
Bore size mm |
6 |
10 |
16 |
20 |
25 |
32 |
Fluid |
Air |
Working way |
Double acting
Single acting(Spring push back),Single acting(Spring push out) |
Highest operating pressure |
0.7mpa |
Lowest
operating
pressure |
Double
acting |
Single shaft |
0.12 |
0.06 |
0.05 |
double rod, no rod turn cylinder Cushion |
0.12 |
0.06 |
0.05 |
no turn double rod |
0.12 |
0.06 |
0.05 |
Single
acting |
Standard |
0.12 |
0.06 |
0.05 |
No rod turn |
0.12 |
0.06 |
0.05 |
Temperature of environment and fluid |
Without magnet:-10°C~70°C With magnet:-10°C~60°C |
Piston Speed |
50~7500mm/s |
Cushion |
Bumper cushion, Air cushion |
Stroke tolerance (mm) |
"+1.0 |
Fix position |
Option |
Fix way |
Free |
piston rod non-rotating precision |
±0.8° |
±0.5° |
Port size |
M5*0.8 |