4h2s-M Hydrogen Sulfide Electrochemical Sensor

Product Specifications

Prod Model:	SEC-4H2S-M
Markets:	North America,South America,Eastern Europe,Southeast Asia,Africa,Oceania,Mid East,Eastern Asia,Western Europe

Product Description

4H2S-M Hydrogen Sulfide Electrochemical Sensor
(P/N: SEC-4H2S-M)
 For more details, please visit www.aerisensor.com 

Technical Specifications
MEASUREMENT
Operating Principle		3-electrode electrochemical
Detection Range		0~100 ppm
Maximum Overload		500ppm
Sensitivity		0.7 ± 0.2 μA /ppm
Response Time (T90)		≤25 s (typical 16S)
Repeatability		<±2% signal
Linearity		Linear
Long term output Drift		<2% signal/month
ELECTRICAL
Resolution	<0.1 ppm
Recommended Load	5~10
Bias Voltage	0 mV
ENVIRONMENTAL
Operating Temp. Range	-40°C ~ 50°C
Operating Humidity Range	15% RH ~ 95% RH non-condensing
Operating Pressure Range	800 ~ 1200 mbar
LIFETIME
Recommended Storage Temp.	0°C to +20°C in sealed container
Expected Operating Life	24 months in air
Storage Life	6 months in original packaging
Standard Warranty	18 months from date of despatch

Cross-sensitivity Data
Gas	Concentration(ppm)	Output signal (ppm H2S equivalent)
Carbon Monoxide	200	1
Ammonia	40	0
Hydrogen Chloride	10	0
Hydrogen	80	0
Hydrogen Cyanide	10	0
Ethylene Oxide	100	0
Nitric Oxide	30	0.5
Nitrogen Dioxide	10	-1

 
Whilst the Gas Sensor are designed to be highly specific to the gas they are intended to measure, they will still respond to some degree to various gases. The table below is not exclusive and other gases not included in the table may still cause a sensor to react. The cross-sensitivity values quoted are based on tests conducted on a small number of sensors. They are intended to indicate sensor response to gases other than the target gas. Sensors may behave differently with changes in ambient conditions and any batch may show significant variation from the values quoted.
SAFETY NOTE:
Connection should be made via a PCB mounting socket. Soldering to pins will void the sensor's warranty.
It is important that exposure to high concentrations of solvent vapours is avoided, both during storage, fitting into instruments, and operation;
If the Gas Sensor is removed from application circuit, a jumper should be added on 'R' and 'S' pin.
As applications of use are outside our control, the information provided is given without legal responsibility. Customers should test under their own conditions, to ensure that the sensors are suitable for their own. The data is given for guidance only. It does not constitute a specification or an offer for sale.