Product Specifications
| Prod Model: |
LC-30B |
| Markets: |
North America,South America,Eastern Europe,Southeast Asia,Africa,Oceania,Mid East,Eastern Asia,Western Europe |
| Function: |
Shining |
Product Description
Electrical painting dryer
INTRODUCE OF INFRARED PAINT CURING LAMP
Unlike the middle-wave and long-wave infrared, the wavelength short-wave has a strong penetration, straight into the paint, then the temperature of the body shell will be raised quickly with heat effect, the moisture of the coating volatilize from inside to outside quickly. In the same layer, therefore, the paint surface is gloss and fullness, and the mirror more clear, coating adhesion is strong, and not easy to produce "orange peel, tearing" phenomenon, avoid reword, reduce cost and improve efficiency.
Baking features:
1. Cut down the energy cost to 75%
2. Working lift of infrared lamp is 5000-7000hours
3. Longest cure time is 15 minutes or so
4. Penetrate the metal plate until finish baking
5. Paint cured within few minutes without dust
6. Operating more effective
7. Less maintenance time and less post processing
8. All these improve your efficiency and reduce cost.
9. Pro-environmental aluminum alloy lampshade
10.304 mirror stainless steel reflectors
11. Specially-made 21 inch high quality short-wave infrared lamp
12. Microcomputer intelligent control humanity design, two LED display, time and temperature can be shown at the same time
13. Pneumatic automatic lifting system
14. Pro- environmental aluminum alloy column
15. Cold rolled steel base deal with rust protection
16. Two-way brake castors
Introduction:
Introduction:
Used in auto local paint, short-wave infrared lamp, there is no need to use spray booth when baking small area, convenience, save time, economical.
Specification:
Lampshade is made of aluminum alloy and stainless steel self-made 21 inch high quality short-wave infrared lamp
Machinery timer
Span power adjusted equipment
Pneumatic automatic lifts can rotate 300 degrees; Can be baked into the small car with any location
Independent control every light
|
Power supply |
200-240V 50/60Hz |
|
Power |
1000W*3 |
|
Baking area |
1000*1200mm |
|
Temperature |
40C-100C |
|
Setting time |
0 min-60min (adjust) |
|
Baking distance |
400-500mm |
|
Putty |
4-6min |
|
Undercoat |
6-8min |
|
Finish |
8-15min |
Guangzhou Anisun Automotive Testing Equipment Co., Ltd. was founded in 2003. It is restructured by Chinese American Mr. Oliver Investment and Anisun in 2007, and set up a joint venture company in Guangzhou. We are researching and manufacturing vehicle testing equipment and testing controlling management system. Our main products includes computer wheel alignment, automobile chassis dynamometer, automobile brake tester, axle loading tester, side sliding tester, speedometer tester, suspension vibration tester, torque angle indicator, wheel partial tester, and so on. We are also sales agents for automobile testing equipments: Light detectors, gas analyzers, opacity smoke meters and other equipment.
Our factory is located in Jiangsu province; its area is more than 12000 square meter. It consists raw-materials workshop, finish machining workshop, welding workshop, treatment workshop, painting/baking workshop, assembling workshop, electrical and electronic controlling production workshop, and testing equipment workshop. We have special R& D department with a group of professional and technical staff.
